SafePoint Scientific Corporation

(A2LA Cert. No. 6956.01) 04/15/2025 Page 1 of 2 SCOPE OF ACCREDITATION TO ISO/IEC 17025:2017 SAFEPOINT SCIENTIFIC CORPORATION 1008 Industrial Drive, Unit D West Berlin, NJ 08091 Ronald Cangro Phone: 609 868 7018 CALIBRATION Valid To: May 31, 2027 Certificate Number: 6956.01 In recognition of the successful completion of the A2LA evaluation process, (including an assessment of the organization’s compliance with R205 – A2LA’s Calibration Program Requirements), accreditation is granted to this laboratory to perform the following calibrations 1, 5: I. Thermodynamics Parameter/Equipment Range CMC2, 4 (±) Comments Temperature – Measure and Measuring Equipment3 R = 0.01 °C R = 0.1 °C R = 1 °C (-100 to 0) °C (0 to 120) °C (120 to 180) °C (-100 to 0) °C (0 to 120) °C (120 to 180) °C (-100 to 180) °C 0.17 °C 0.12 °C 0.17 °C 0.18 °C 0.13 °C 0.18 °C 0.60 °C Fluke 1523 with PRT R = UUT resolution Humidity – Measure3 (10 to 90) % RH (90 to 95) % RH 1.5 % RH 1.4 % RH Vaisala hygrometer ___________________________________________ 1 This laboratory offers commercial calibration service.

(A2LA Cert. No. 6956.01) 04/15/2025 Page 2 of 2 2 Calibration and Measurement Capability Uncertainty (CMC) is the smallest uncertainty of measurement that a laboratory can achieve within its scope of accreditation when performing more or less routine calibrations of nearly ideal measurement standards or nearly ideal measuring equipment. CMCs represent expanded uncertainties expressed at approximately the 95 % level of confidence, usually using a coverage factor of k = 2. The actual measurement uncertainty of a specific calibration performed by the laboratory may be greater than the CMC due to the behavior of the customer’s device and to influences from the circumstances of the specific calibration. 3 Field calibration service is available for this calibration. Please note the actual measurement uncertainties achievable on a customer's site can normally be expected to be larger than the CMC found on the A2LA Scope. Allowance must be made for aspects su ch as the environment at the place of calibration and for other possible adverse effects such as those caused by transportation of the calibration equipment. The usual allowance for the actual uncertainty introduced by the item being calibrated, (e.g., re solution, repeatability) must also be considered and this, on its own, could result in the actual measurement uncertainty achievable on a customer’s site being larger than the CMC. 4 The type of instrument or material being calibrated is defined by the parameter. This indicates the laboratory is capable of calibrating instruments that measure or generate the values in the ranges indicated for the listed measurement parameter. 5 This scope meets A2LA’s P112 Flexible Scope Policy.