ISO 16750-2 Accredited Testing Labs Worldwide

ISO 16750-2 (Sections 4.6.3 and 4.6.4 only) Vehicle and Machinery Standards ISO 13766-1; EN ISO 13766-1; ISO 13766-2; ISO 14982; EN ISO 13766-2 (except ISO 11452-5, ISO 12100, ISO 12630, ISO 13849, and ISO 15998); EN 14982 (exc

ISO 16750-2:2006* Road vehicles Environmental conditions and testing for electrical and electronic equipment Part 2: Electrical loads Auto- motive ISO 16750-2:2012* Road vehicles Environmental conditions and testing for electrical an

ISO 16750-2:2012; ISO 16750-2 (2023); Ford ES-XW7T-1A278-AA

ISO 16750-2: 2012-11 Fourth edition Road vehicles – Environmental conditions and testing for electrical and electronic equipment – PART 2 loads EMV UN ECE R10 REV. 6 + Amendment 1 30.10.2020 R 10 Uniform provisions concerning t

ISO 16750-2 Oscilloscope, voltage probe, digital multimeter Automotive-Transient Pulse Simulators Road Vehicles – Electrical Disturbanes Conduction & Coupling Voltage Rise Time Duration Up to 600

ISO 16750-2:2023 Tecnica di prova O&I _ Denominazione della prova / Campi di prova Metodo di prova Tecnica di prova O&I Emissioni elettromagnetiche irradiate/Radiated emission Prove di immunità ai campi elettromagnetici irradiati/R

ISO 16750-2 Absorber Lined Shielded Enclosure (ALSE) RF Immunity (80 MHz to 6 GHz) Up to 200 V/m (Metallic Bench Only) Up to 600 V/m (Radar Pulse Only) ISO 11452-2; E/ECE/324/Add. 9 R10 (section 6.8) TEM Cell RF Immuni

ISO 16750-2: 2023-07 Road vehicles — Environmental conditions and testing for electrical and electronic equipment Part 2: Electrical loads Without Ch. 4.13 (EMV) Elektrische Prüfungen IEC 60512-2-1: 2002-02 Connectors for elect

ISO 16750-2:2012, ISO 16750-2, JASO D 001 Standard equipment: oscilloscope

ISO 16750-2 2023/07 Road vehicles – Environmental conditions and testing for electrical and electronic equipment Part 2: Electrical loads Nicht 4.9 "Withstand voltage"; Nicht 4.10 "Insulation resistance" EMV ISO 21498-1 2021/

ISO 16750-2 2012-11 [Flex A] Road vehicles - Environmental conditions and testing for electrical and electronic equipment - Part 2: Electrical loads 4.11 Withstand voltage 4.12 Insulation resistance Elektrotechnik ISO 16750-2 202

ISO 16750-2; ISO 21498-2; GB/T 28046.2; VW 80300; VW 80303 Current Harmonics GB 17625.1; IEC 61000-3-12; IEC 61000-3-2

Parameter/Equipment5 Range CMC2, 12, 13,14 (±) Comments6 Time Interval & Frequency3 (cont) – Voltage Transient Emission3 Switching Time Transient Immunity3 Surge Pulse & Load Dump Pulse Rise Time Dur

ISO 16750-2 2012-11 Ed. 4.0 Road vehicles - Environmental conditions and testing for electrical and electronic equipment - Part 2: Electrical Loads ISO 7637-2 2011-03 Ed. 2.0 Straßenfahrzeuge - Elektrische, leitungsgeführte und

ISO 16750-2 Road Vehicles – Environmental Conditions and Testing for Electrical and Electronic Equipment Part 2: Electrical loads (excluding Clause 4.13 Electromagnetic Compatibility) Battery Testing DOE/ID-11069 Ineel Battery Test Man

ISO 16750-2:2023 Road vehicles -- Environmental conditions and testing for electrical and electronic equipment - Part 2: Electrical loads Abbreviations used: CISPR Comité international spécial des perturbation s r

ISO 16750-2; GB/T 21437.3; GB/T 28046.2; SAE J1113-12 1 When the date, edition, version, etc. is not identified in the scope of accreditation, laboratories may use the version that immediately precedes the current version for a per

ISO 16750-2 (2012); Hyundai/Kia ES 96200-00; ECE R10.07 Stripline Test (Immunity) ISO 11452-5 1When the date, edition, version, etc. is not identified in the scope of accreditation, laboratories may use the version that immediate

ISO 16750-2; GB/T 28046.2

ISO 16750-2:2012 Road vehicles — Environmental conditions and testing for electrical and electronic equipment — Part 2: Electrical loads EMV ISO 21780:2020 Road vehicles — Supply voltage of 48 V — Electrical requirements and tests

ISO 16750-2, UL1449, GR1089 Tektronix TDS5104 w/high voltage deferential probe & current probe Flicker & Harmonics – Measure Voltage Fluctuations (Flicker) Mains Harmonic Emissions 230V, 50 Hz

ISO 16750-2:2012 Road Vehicles – Environmental conditions and testing for electrical and electronic equipment Part 2: Electrical loads EMV ISO 16750-2:2023 Road Vehicles – Environmental conditions and testing for electrical and electr

EMV ISO 7637 -2:2011 Road vehicles - Electrical disturbances from conduction and coupling - Part 2: Electrical transient conduction along supply lines only EMV ISO 7637 -3:2016 Road vehicles - Electrical disturbances from c

ISO 16750-2 / Electrical loads Load dump (Pulse 5b) Oscilloscope, Transient generator, Voltage probe, Resistor Time (s) Voltage (V)

Fachbereich Norm oder Prüfverfahren / Ausgabestand Titel der Norm oder des Prüfverfahrens Einschränkungen zum Prüfverfahren / Standort EMV Volvo STD 515 -0003 Version 2 2006/05 Volvo Group PARTS AND COMPONENTS Electro-ma

ISO 16750-2 Emissions Harmonics and Flicker EN 61000-3-2; IEC 61000-3-2; AS/NZS 61000.3.2; SANS 61000-3-2; EN 61000-3-3; IEC 61000-3-3; AS/NZS 61000.3.3; SANS 61000-3-3 Conducted (Excluding Broadcast Receivers)

Bereich Norm oder Prüfverfahren / Ausgabestand Titel der Norm oder des Prüfverfahrens Prüfbereich / Einschränkungen EMV DIN EN 62920:2018 -07 Photovoltaische Stromerzeugungssysteme - EMV- Anforderungen und Prüfverfahren für Leist

ISO 16750-2: 2012 ISO 16750-2: 2023 Road vehicles -- Environmental conditions and testing for electrical and electronic equipment -- Part 2: Electrical loads EMV ANSI C63.4:2014 American National Standard for Methods of Measureme

ISO 16750-2 (excluding ISO 11451, ISO 11452-3/5/10 and CISPR 12)

ISO 16750-2; GMW 3172 Sections 8.2 & 9.2 Radiated & Conducted Emissions (Unintentional) 47 CFR FCC Part 15, Subpart B (using ANSI C63.4-2014); ICES-003 Radio (Unlicensed Intentional Radiators) 47 CFR, FCC Part 15, Subpa

ISO 16750-2 Tri-Plate Line Method SAE J1113-25 Emissions Radiated ANSI C63.4 (up to 18 GHz) Conducted ANSI C63.4 (150 kHz to 30 MHz); CISPR 16-2-1 (Measurements with AMN only, continuous disturbances only) Harmonics UN

ISO 16750-2 (2023); ISO 16750-2 (2010, 2012); ISO 16750-2; SAE J1113-13 Automotive Electrical Tests of the following types: Test(s): Test Method(s) 1: - Jump Start - Reverse Polarity - Over Voltage - State Change Waveform Ch

ISO 16750-2 II. Electrical – RF/Microwave Parameter/Equipment Range CMC2, 4, 6 (±) Comments RF Power3 – Measure 9kHz to 7 GHz (-70 to +20) dBm 0.3 dB Spectrum Anal

ISO 16750-2 (2010, 2012) * Also using customer-specified methods related to the types of tests listed above.

Prüfungen in den Bereichen: ausgewählte elektrische Messungen Innerhalb der mit * gekennzeichneten Akkreditierungsbereiche ist dem Prüflaboratorium, ohne dass es einer vorherigen Information und Zustimmung der DAkkS bedarf, die Anwendu

ISO 16750-2; UNECE Regulation 10, Revision 6, Electronic Sub-assemblies (ESA), Sections 6.7, 6.9, 7.17, 7.19 Wireless (Excluding HAC & SAR) ANSI/TIA 603-E; EN 300-113; EN 300 220-1; EN 300 220-2;

Parameter/Equipment Range CMC2 (±) Comments RF Speed Guns – Speed (5 to 1000) m/s 0.09 m/s Agilent 33210A, HP 53152A, NSI-MI Technologies MI-210-26A Surge Generators3 – Voltage

ISO 16750-2:2012-11 Edition 4 Road vehicles - Environmental conditions and testing for electrical and electronic equipment - Part 2: Electrical loads Keine Prüfungen nach Abschnitt 4.6.4

ISO 16750-2:2012 Straßenfahrzeuge - Umgebungsbedingungen und Prüfungen für elektrische und elektronische Ausrüstungen - Teil 2: Elektrische Beanspruchungen Road vehicles - Environmental conditions and testing for electrical and elect

ISO 16750-2: 2012 Range 12VDC - 24VDC, Level I - IV Fordonskomponenter Nej Only testing of starting profile 4.6.3 and load dump 4.6.4 ISO 7637-3: 2016 Range 12VDC - 24VDC, Level I - IV Fordonskomponenter Nej Only test method CCC and IC

Fachbereich Norm oder Hausverfahren / Ausgabestand Titel der Norm oder des Hausverfahrens Einschränkungen zum Prüfverfahren Automotive Components ISO 8820 -5:2015 Road vehicles - Fuse -links - Part 5: Fuse-links with axial term

ISO 16750-2) Vedere elenco dei dettagli delle prove flessibili/See list of flexible scope details Vedere elenco dei dettagli delle prove flessibili/See list of flexible scope details Vedere elenco dei dettagli delle prove flessibili/See

ISO 16750-2; IEC 61851-21-2; UN ECE REG 10 (Automotive) Earth-moving and building construction machinery – Machines with internal electrical power supply ISO 13766-1; ISO 13766-2 Unintentional Emissions Radiated & Conducted U

ISO 16750-2:2012 Strassenfahrzeuge – Umgebungsbedingungen und Prüfungen von elektrischer und elektronischer Ausrüstung – Teil 2: Elektrische Beanspruchung. Verfahren von ausländischen Normungsorganisationen EMC / Radio IEEE ANSI C63

ISO 16750-2; MBN 10567; GS 95024-2 Section 7.1~7.26 Road vehicles — Supply voltage of 48 V — Electrical requirements and tests ISO 21780 1 When the date, edition, version, etc. is not identified in the scope of accreditatio

ISO 16750-2:2012 Straßenfahrzeuge - Umgebungsbedingungen und Prüfungen für elektrische und elektronische Ausrüstungen - Teil 2: Elektrische Beanspruchungen EMV ÖVE/ÖNORM EN 50498:2011 Elektromagnetische Verträglichkeit (EMV) - Pr

ISO 16750-2; Magnetic Field Immunity ISO 11452-8 (excluding Helmholtz Coil method) Conducted and Transient Immunity ISO 7637-2; ISO 7637-3; Conducted and Transient Immunity ISO 13766-1; EN ISO 13766-1; ISO 13766

Parameter/Equipment Range CMC2, 4, 8 (±) Comments 7637 Pulse Generator3 – Pulse 1, Pulse 2a, 2b, Pulse 3a, 3b, Pulse 5a, 5b: Vo lt a ge Rise Time Duration (0.1 to 660) V 1 ns to 5 µs 100 ns

ISO 16750-2; ISO 16750-2 (2010, 2012) Conducted Transient Immunity ISO 7637-2; ISO 7637-2 (2004, 2011); ISO 7637-3; ISO 7637-3 (2016); SAE J1113-11; SAE J1113-12 Conducted Transient Emissions ISO 7637-2; ISO 7637-2 (2

ISO 16750-2; ISO 16750-2:2012, Sections 4.6.3 and 4.6.4 Immunity to Magnetic Fields (10Hz to 150kHz) ISO 11452-8; ISO 11452-8:2015, Section 7.4 Portable Transmitters Immunity ISO 11452-9; ISO 11452-9:2012 IC Conducted Emissio